Assume you want to segment part of your network into its own isolated piece by using a VRF, how would you do this with VOSS?

ip vrf itstaff vrfid 1

vlan create 999 name “ITStaff” type port-mstprstp 0

vlan members add 999 1/8

interface vlan 999

vrf itstaff

ip address 192.168.99.2 255.255.255.0

exit

VRF “itstaff” includes VLAN 999 name “ITStaff” and is the only VLAN created so far in the VRF and the VRF has its own routing table.

VSP-1100:1(config)#show ip route vrf itstaff
************************************************************************************
Command Execution Time: Fri Apr 09 09:46:41 2021 UTC
************************************************************************************
=====================================================================================================
IP Route – VRF itstaff
=====================================================================================================
NH INTER
DST MASK NEXT VRF/ISID COST FACE PROT AGE TYPE PRF
—————————————————————————————————–
192.168.99.0 255.255.255.0 192.168.99.2 – 1 999 LOC 0 DB 0

1 out of 1 Total Num of Route Entries, 1 Total Num of Dest Networks displayed.
————————————————————————————————–
TYPE Legend:
I=Indirect Route, D=Direct Route, A=Alternative Route, B=Best Route, E=Ecmp Route,
U=Unresolved Route, N=Not in HW, F=Replaced by FTN, V=IPVPN Route, S=SPBM Route
PROTOCOL Legend:
v=Inter-VRF route redistributed
VSP-1100:1(config)#

Note: To test connectivity from the CLI with ping or traceroute remember to specify the VRF on the command line otherwise it will use the GRT and results will not be as expected.